This thread looks to be a little on the old side and therefore may no longer be relevant. Please see if there is a newer thread on the subject and ensure you're using the most recent build of any software if your question regards a particular product.
This thread has been locked and is no longer accepting new posts, if you have a question regarding this topic please email us at support@mindscape.co.nz
|
Hello, sometimes, when I scroll the diagram surface, the BoundsChanged event of some nodes are fired, but I haven't change the bounds of any node. Thanks |
|
|
|
|
Thanks for pointing this out Jzhou This will be resolved in the next nightly build. -Jason Fauchelle |
|
|
|
|
Hello, thanks for your quick fix. The unexpected event is not fired, but I found some connections don't reach the connection points, those nodes are not in the viewport at the beginning, I scroll to make them visible, please see the attached picture, thanks |
|
|
|
|
Hello Jzhou I have not been able to reproduce this. Did this only occur after getting that nightly build? The only thing I can imagine is that the segments are somehow saved/loaded wrong. The redundant event would have triggered a recalculation of the segments. Unfortunately I have not been able to reproduce this theory either. If you move one of the nodes, does the connection correct itself? To solve this one, I will need a file that this diagram was deserialized from (if it was loaded from a file that is), or I may even need a simplified repro project. This can be sent to my email if it is too big or sensitive to post here. jason@mindscape.co.nz -Jason Fauchelle |
|
|
|
